Cass17
Senior Scrapper

Hey...just a note...I finally got the bow maker in the mail to you! Sorry it's so late... so much going on then down time...I'm trying to get organized again... and you were first on the list! Hope you like!

Clarinda

I'm sending you a PM

Hi Cass ..can u send me a catalog.. i'd like to place an order thanks

Happy Birthday to you, happy birthday to you, happy birthday dear Cass....happy birthday to you!!!
Your lucky you can't really hear me singing that !! Have a wonderful day.

Hi Cass, I wondered if you had had a chance to read my previous question about the store near Lancaster. Also, you mentioned going to Valley Forge. How far away is that from you and how far away do you live from Gettysburg?

Cass, I've heard about the Flower & Craft Warehouse you mentioned today. Isn't it outside Lancaster neat the outlets? I've been considering going there, but we're almost 2 hours away. I would go to the outlets, too, but would still like to know what the store is like as far as SB merchandise. Thanks, Sue

Hi Cass, You might want to read a new response I just wrote in about your CK mag.thread. This is a new one I just wrote today. I found some information that I had torn out of a magazine that I think you may be interested in. And I'm writing to you privately since I wasn't sure you would check your thread out again. Hope this helps. I'm interested in it, too, and gave them my email address. Take care, Sue

Hi Cass, we are getting serious about our kitchen cabinets & have been getting prices. I like the idea of the pull-out shelves, but my main concern is storage space. Don't the pull-outs take up quite a bit of space?

I was just checking to see if you had read my PM to you about the butterfly die. I know you're busy, but at least I know that my PM got posted. Just get back to me when you have time. Thanks, Sue

Hi Cass, I finally got a chance to use my new butterfly die. I'd like to get some tips from you. I'm using it in my C-Bug. I have never used a QuicKutz before, but am using the formula that I have. The one I made is rather difficult to get the small pieces out. Do you have the same problem? I did not use any of the things that came with the die other than the 1 die itself. Then I use the Bug plates. Am I doing anything wrong or are the small pieces just difficult to remove? Thanks for your help. Sue